Forum Discussion
Does Gen5 allow a public IP Adress and port forwarding?
I use IP Centcom App on Windows phone to access my DVR to view curveillance cameras. With Netgear router I used IP address and forwarding port 80 and 554. I am at a loss with Gen 5....Eddie
If you already had a Router I would just use that. Turn off all WiFi on the HughesNet Gen5 modem by going to WiFi Settings and uncheck the box next to SSID Enable for 2.4Ghz and also for 5Ghz. (Save after each). Then just plug Your router into the HughesNet modem, all your old settings with your Router will be the same as before. (I am pretty sure this will fix your problem but not exactly sure). If your PC needs to be Ethernet plug it into the Modem itself NOT the Router.
Gen5 doesn't allow for public IP Addresses, which makes port-forwarding impossible... The only way to remote access your network is to use something like Teamviewer, or to connect over IPv6 and use something like noip.org to reach your home network.
Going the IPv6 route, all devices must fully support IPv6, and the address will change from time to time.
I do not have any IPv6 internet access with my current Gen 5 . How could I use IPv6/ even more confused now ..Eddie
