- Hughesnet Community
- :
- About Jere Cox
Hughesnet Community
About Jere Cox
New Poster
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
4
Posts
0
Kudos
0
Solutions
Contact Me
| Online Status |
Offline
|
| Date Last Visited |
12-23-2020
01:25 AM
|
04-30-2017
03:10 PM
Thanks. I figured it out by going to the Admin page then going to Advanced Setup then to Wireless. There I can disable both 2.4GHz and 5GHz. So far it apears to have solved the connection problem.
... View more
04-30-2017
02:04 PM
How do I disable the wireless function on the HT2000w?
... View more
04-30-2017
12:17 PM
So after some forum exploration, I think the issue lies in the fact that the Gen5 HT2000w is both a router and modem. With the Gen4 device it was only a router which I connected to my Apple Airport Extreme and on into the rest of my devices in my wifi network. I had no wireless problems what so ever. So I'm thinking that the HT2000w needs to "bridge" to the Airport Extreme which then would transmit the wifi signal to the entire network. Is it possible to set the HT2000w to Bridge Mode? Right now the only way I can get internet service is to plug into the Ethernet and this is only for my laptop. This leaves out all of the rest of our devices which rely on a wifi connection. I just may have to go back to the Gen4.
... View more
04-29-2017
01:03 AM
I just upgraded to Gen5. With the Gen4 I had it hooked up to my Apple Airport Extreme base stations. No problems. With the Gen5 I right away had a NAT conflict and couldn't use the Apple network. Had to go straight ethernet. I know I have to reconfigure each base station to "extend the network." So I have to connect an ethernet cable from the Hughes router/modem to my Airport Extreme base station. But when I initiate the configuration I get an error message that it cannot find the Hughes and base stations on the network. But the Hughes router/modem is the base station correct? I've tried a reset, and a hard reset of the Apple Extreme which is connected the the Hughes station. But in the extend mode it cannot find the Hughes base station. The network names are correct so that would assume that's not the problem. So what gives? Anyone out there have experience connection a Hughes system to an Apple wireless system? Jere
... View more
Labels:
- Labels:
-
Gen5
Latest Tags
No tags yet
- Hughesnet Community
- :
- About Jere Cox