Should I enable or disable the firewall if I'm using an external router?
Should I leave the firwall enabled or disable it if I have wifi off and only using an external router with a firewall? Generally, I would disable it if I'm using the another modem device like a DSL with an external firewall to avoid double NAT. But, since there is no bridge mode and the router is basically always in play on the ht2000w, should I just leave it enabled? Plus as I understand the ht2000w is always translating ipv4 addresses because the Hughes side of the gateway is only ipv6. What are your thoughts and or advice?Solved7.1KViews0likes6Comments
Sonicwall TZ600 and HT2000W
Looking around the community I am not able to find if the HT2000W will work with a SonicWall TZ600. To create a Wan Zone within a Sonicwall you need to have a static ip, subnet mask and a gateway. I purchased a static ip with my Hughesnet service but was told by a Hughesnet support rep that they no longer use subnet mask and gateways?5.1KViews0likes4Comments