Forum Discussion
Have to move dish on roof.
Due to construction and interference, I have to move my dish further up the roof about 5 feet. I measured and put it in the same orientation as it was but now I seem to have lost alighment with the ...
Never move a satellite dish without first contacting the company responsible for the dish.
The best information I can give you for that is to navigate to the Advanced page of your HT2000w, click Installation, then click Install, and do a Re-Install... That is the only way to get "real-time" numbers, which are still delayed by just a few seconds.
However, I highly suggest not doing this... Whether you point at the right satellite to get a signal is up in the air. Even if you manage to point at the right one, if you mess up your LAT/LONG entries, or if your HT2000w was setup with a beam over-ride then it still wont work. There are also SBC Config files that *might* need updating on your terminal that only a technician can do.
'comfortable' == technically inclined and have the appropriate aiming equipment/skills.
I really wouldn't recommend it being doable to the general public, because without the prerequisites it's just dumb luck if it works.
Yes, I should have made that more clear. I have significantly more IT training than most.
