ht1100 modem 192.168.0.1 DHCP is enabled system control center tests are run, no problems, no error messages I have reseated the network cable, rebooted both network cable came with the router and so its basically new and I tried swapping already. I purchased the router about a month ago since the netgear was several years old The netgear router worked fine for about 2 months after starting Hughesnet and then connectivity issues began so I bought a new router which seemed to solve the problem for a while I had one service call which didn't help anything since the problem was sporadic The belkin router was working fine and then a few weeks ago my phone battery was being used up and I discovered it was constantly scannning the wifi every 4 seconds. This issue only occurs at my house as both my tablet and phone are fine anywhere else. In the middle of typing this message the connection was lost and then regained in a couple of minutes. Either the scanning is causing me to lose connectivity or I'm loosing connectivity first and then the scanning starts. Thanks for any assistance you can give me. I'm honestly ready to just pay the disconnect penalty as I can say it only works 50% of the time.
... View more