Forum Discussion

Camaro68's avatar
Camaro68
New Poster
6 years ago

Have to move dish on roof.

Due to construction and interference, I have to move my dish further up the roof about 5 feet.  I measured and put it in the same orientation as it was but now I seem to have lost alighment with the ...
Performance
  • C0RR0SIVE's avatar
    C0RR0SIVE
    6 years ago

    Never move a satellite dish without first contacting the company responsible for the dish.

    The best information I can give you for that is to navigate to the Advanced page of your HT2000w, click Installation, then click Install, and do a Re-Install...  That is the only way to get "real-time" numbers, which are still delayed by just a few seconds.

    However, I highly suggest not doing this...  Whether you point at the right satellite to get a signal is up in the air.  Even if you manage to point at the right one, if you mess up your LAT/LONG entries, or if your HT2000w was setup with a beam over-ride then it still wont work.  There are also SBC Config files that *might* need updating on your terminal that only a technician can do.

MarkJFine's avatar
MarkJFine
Professor

'comfortable' == technically inclined and have the appropriate aiming equipment/skills.

I really wouldn't recommend it being doable to the general public, because without the prerequisites it's just dumb luck if it works.

maratsade's avatar
maratsade
Distinguished Professor IV
6 years ago

Dumb is right.  

 

It's also prohibited by the subscriber agreement:  

Unless you have purchased your Equipment from Hughes, the satellite modem, power supply, and radio (outdoor transmitter) to be installed by Hughes at your premises will remain the property of Hughes and shall not be deemed fixtures or part of your realty. You shall have no right to pledge, sell, mortgage, otherwise encumber, give away, remove, relocate, alter, or tamper with the Equipment (or any notice of our ownership thereon) at any time. Any reinstallation, return, or change in the location of the Equipment shall be performed by us at our service rates in effect at the time of such service. You are responsible for preventing the loss or destruction of all Equipment provided pursuant to this Agreement.

 

Given that moving the dish involves moving the radio, whoever does their own relocating and reaiming, regardless of how technically brilliant they may be, would be in direct violation of the service agreement and might be liable for any problems, not to mention financially responsible.   

 

Edit: even if the subscriber has purchased the equipment, it would still be quite unwise to tamper with it (and they would still be financially responsible for fixing it). 

  • infinitytec's avatar
    infinitytec
    Junior
    6 years ago

    However, I would plead right to repair, although we are leasing the equipment. We were prepared to pay the service fee to get back online if I couldn't get it, but considering we had some problems communicating with the service people (one I think never got back to us) and I got it to work, it saved some money. It's also a temporary solution for us, as we will be switching to a more permanent one soon.

     

    It would definitely be dumb for some people to attempt it; I almost couldn't figure it out, but hey, I know how now. Kind of fun to set up communication with a satellite.

    • maratsade's avatar
      maratsade
      Distinguished Professor IV
      6 years ago

      "However, I would plead right to repair, although we are leasing the equipment."

       

      You would still be in violation of the agreement.  It's good you're prepared to deal with the consequences.