Forum Discussion
Signal going down for some reason
Serial Number: B1-0005494030-A4 So we have another problem where the signal goes down very low. This has happened two days this week, during the night time hours. It is clear outside currently. Righ...
Aedan wrote:
Good Morning all and thanks for posting!
Gabe, there was a technical issue at your gateway that affected your beam on 7/28. Arceus213, your beam was affected by severe weather on 7/28 and 7/29. Arceus213, I also pulled up your account to troubleshoot. Your system is showing state code 13.2.2. Please verify that the LAN cable on one end is connected to the LAN port on the back of the modem and the other end to your computer. Thanks.
Actually, the ethernet cable is connected from the Hughesnet HT1100 Modem to the Linksys E2500 wireless modem. Unfortunately, I wasn't at my home during the week, so there was no computer turned on at the time. Other than that, the internet is working fine right now.
Hello arceus213,
Thank you for the prompt response. We have sent you a free replacement modem (HT1100). Please look out for it in a couple days. Thanks.
So we had got the modem either Tuesday or Wednesday. All was fine most of the week, until the low signal issue happened again a little bit ago. The only difference is that it occured for almost an hour.
This was the downlink state code before it changed to 11.2.1 as shown in this picture:
The uplink state code was 12.2.1. I had reset the modem to see if the problem was solved, but it still occured as shown in this picture:
The current diagnostic code is 0000-0000-0000-0027.
P.S. Forgot to say that the Modem's serial number is B3 0010751134 A3.
Okay.
This is what I saw. Note that the signal strength went to the exact same level. This was after resetting the modem in an attempt to fix it, which explains the low packet count. I made sure to capture it just in case....
Good Morning all and thanks for posting!
Gabe, there was a technical issue at your gateway that affected your beam on 7/28. Arceus213, your beam was affected by severe weather on 7/28 and 7/29. Arceus213, I also pulled up your account to troubleshoot. Your system is showing state code 13.2.2. Please verify that the LAN cable on one end is connected to the LAN port on the back of the modem and the other end to your computer. Thanks.
Ah. Okay. Thank you. I figured it was something technical, as when it's been out due to a storm over the years it's acted a bit differently, with the signal strength being all over the place, and the system pretty much working immediately after that signal was back up to "strong enough", but not this time. Plus, I know that my gateway is in Roseburg, OR, and there was nothing going on anywhere around there at the time.
Oh, wait. Can I get a three cent offset for the month, due to it being down for a half hour? J/K!!! :p
Aedan wrote:
Good Morning all and thanks for posting!
Gabe, there was a technical issue at your gateway that affected your beam on 7/28. Arceus213, your beam was affected by severe weather on 7/28 and 7/29. Arceus213, I also pulled up your account to troubleshoot. Your system is showing state code 13.2.2. Please verify that the LAN cable on one end is connected to the LAN port on the back of the modem and the other end to your computer. Thanks.
Actually, the ethernet cable is connected from the Hughesnet HT1100 Modem to the Linksys E2500 wireless modem. Unfortunately, I wasn't at my home during the week, so there was no computer turned on at the time. Other than that, the internet is working fine right now.
