Forum Discussion
Connection is off and on
- 7 years ago
Hi jd697, thanks for reaching out. I pulled up your account, and through my investigation I did see some dip in service that showed from recent activity, though it seemed to sort itself out. I ran a test through the system that should improve connection, it may take up to a few hours before we see results.
Let us know how things are running.
-Brooke
At this point, the best thing you can do is to make sure that the coax connector at the back of the modem is finger tight, and if your modem is plugged into a power strip or surge protector try plugging it directly into a wall outlet, as those two devices can sometimes interfere with proper power throughput. It would also be a good idea to make sure that the power plug at the back of the modem is snug. Be careful, as it's a very delicate plug (it has multiple pins), but just make sure it's not loose.
In the meantime, it would be best for you to leave your HughesNet modem plugged in, if you don't already, so that the reps can run remote diagnostics on your HughesNet equipment to see what's going on. They're on M-F from approximately 8AM to 5PM EST. They normally reply within a day, but if they're very busy it can sometimes take them a little longer.
- jd6977 years agoFreshman
Thanks for the response GabeU. I checked the coax and the power plug connections and they are good. I will try to find a wall outlet that I can plug the modem into instead of the surge protector. So far this morning everything is working ok. I will see how it works throughout the day and report back.
- jd6977 years agoFreshman
Unfortunately I am still having problems losing connection. It worked fine for a few hours this morning, but then dropped out again around noon. The connection dropped several more times this afternoon and I rebooted to get it back up. It works fine when it is working. When it goes down the system state code is usually 30.1.1. I do have the modem plugged directly into the wall outlet. I am on Echostar-XVII. Beam ID 20.
Related Content
- 2 years ago
- 10 months ago
- 3 years ago