Forum Discussion
5GHz won't load on new Gen5 router
- 8 years ago
Right now the only fix for the missing 5Ghz band is to reboot the modem, I am sure Hughes is busy working on a fix to keep that from happening.
- 8 years ago
Unless there is a specific reason that you need to use the 5Ghz radio, the 2.4Ghz radio is fine, and it's the one most people would be better off using. You don't need a new laptop.
The 5Ghz radio was designed to help in situations where there is interference with the 2.4Ghz frequency, like may occur in apartment complexes and such. It can also transmit data at higher speeds, but the speeds of Hughesnet don't approach anything near where the 5Ghz frequency would be of an advantage in that aspect. 2.4Ghz can transmit up to about 450Mbps, whereas 5Ghz can transmit up to about 1300Mbps. Hughesnet Gen5 tops out at about 50Mbps. When it comes to range, the 2.4Ghz is much better, and is better at transmitting through walls and such. 5Ghz doesn't do this well.
As to why the 5Ghz radio isn't showing up in your options for connection...you got me. It doesn't show up on my laptop or notebook, either, and both can handle 5Ghz signals.
It's possible that your Asus (and my laptop and notebook) automatically defaults to the 2.4Ghz frequency and only shows this when both are available, though this is only a guess and it could very well be wrong. I'm not terribly versed on Wi-Fi, but read about the differences between the two frequencies and why to use one over the other.
While I don't receive my 5G modem/router/WiFi till Tuesday, I was planning on continuing to use my existing router (with working 5G WiFi) once the new modem is setup. Probably just turn off the WiFi and firewall on the new modem. I've run into the same problem you are having with other routers in the past. Sometimes, a firmware update fixed. We don't Know when there will be a firmware update for the new modem. Is there any reason you can't continue to use a third party router/WiFi? Speed should not be an issue if they are gigabit ports.
- C0RR0SIVE8 years agoAssociate Professor
Right now the only fix for the missing 5Ghz band is to reboot the modem, I am sure Hughes is busy working on a fix to keep that from happening.
- JSHILLIDAY388 years agoNew Poster
I just got the Gen5 and the 5Ghz does not even show up as an option for the wifi. Talked to someone at Hughes and they claimed all was well on their end and that my laptop is "probably" to old to support this new dual band modem. Does this sound right? I'm using an Asus that is a couple years old. When I check the wifi on the laptop, it's using the 2.4Ghz hug2 wifi. I have not seen 5Ghz at any time as an option, or that it is even there. Now, I am an admitted luddite, no solution is obvious or easy. I read where rebooting the modem may solve the problem...how do u do that, just power it down and then turn it back on? Anyway, whomever I talked to at hughes is convinced that I need a new laptop that can operate with the dual band modem. Any help would be appreciated.
- GabeU8 years agoDistinguished Professor IV
Unless there is a specific reason that you need to use the 5Ghz radio, the 2.4Ghz radio is fine, and it's the one most people would be better off using. You don't need a new laptop.
The 5Ghz radio was designed to help in situations where there is interference with the 2.4Ghz frequency, like may occur in apartment complexes and such. It can also transmit data at higher speeds, but the speeds of Hughesnet don't approach anything near where the 5Ghz frequency would be of an advantage in that aspect. 2.4Ghz can transmit up to about 450Mbps, whereas 5Ghz can transmit up to about 1300Mbps. Hughesnet Gen5 tops out at about 50Mbps. When it comes to range, the 2.4Ghz is much better, and is better at transmitting through walls and such. 5Ghz doesn't do this well.
As to why the 5Ghz radio isn't showing up in your options for connection...you got me. It doesn't show up on my laptop or notebook, either, and both can handle 5Ghz signals.
It's possible that your Asus (and my laptop and notebook) automatically defaults to the 2.4Ghz frequency and only shows this when both are available, though this is only a guess and it could very well be wrong. I'm not terribly versed on Wi-Fi, but read about the differences between the two frequencies and why to use one over the other.
- Rkrauter8 years agoNew Poster
Yeah, I'm seeing this issue too. 5Ghz wireless drops out, not shown as available WIFI. Have to power cycle the HT2000W to bring it back. It's starting to be annoying!
- GabeU8 years agoDistinguished Professor IV
Rkrauter wrote:Yeah, I'm seeing this issue too. 5Ghz wireless drops out, not shown as available WIFI. Have to power cycle the HT2000W to bring it back. It's starting to be annoying!
It seems that some HT2000Ws are experiencing this issue, and Hughesnet is working on it. In the meantime, other than rebooting, you could try the 2.4Ghz band and see if that works well enough, or you can even use a separate router with the HT2000W if you have one.
Related Content
- 8 years ago
- 10 months ago
- 3 years ago
- 5 years ago
- 5 years ago